Just a quick post to mention the first results of my Soybean Inoculant experiments. The experiments were to see if:
- Commercial soybean inoculant was able to be used for a second season despite the use by date on the packet.
- I could produce my own diy inoculant using soil from pots in which soybeans had been grown.
The reason that I need to use Soybeam Inoculant is that the native rhizobia are not present in UK soils. My reason for growing soybeans was to see if they reduced the incidence of scab in a following potato crop. I bought some inoculant from the USA, but didn’t want to keep buying it for four years until all of my beds had some soybean rhizobia present. The packet was supposed to be only good for a single season.
I planted up four Rootrainers with pre germinated soybeans, collected from plants grown last year. Three were planted up using soil from pots that had grown soybeans last year. The fourth had commercial inoculant sprinkled over the seeds when sown.
The Results So Far
Today I planted out the rootrainer that had the commercial soybean inoculant added. All of the plants had rhizobia present in root nodules, as can be seen from the pictures below.
The first picture shows the rhizobia in nodules on the roots of a soybean plant.
The second picture is of the same roots but as a close up. There were not a lot of root nodules, but it has only just warmed up, so microbial activity would have been low until recently. As the weather warms up, root colonisation should increase.
DIY Soybean Inoculant
It will be at least a week before the first of the roottrainers with the DIY soybean inoculant is planted out in my new polytunnel. I will wait until then to see if my attempts to create my own inoculant have been successful.